Replace the charging port and charging port cover

Replace the front controls and turn signals You are reading Replacing the Charging Port and Charging Port Cover 3 minutes Continue Replacing Controls and Turn Signals
Tags

In this guide, we'll show you, step by step, how to replace the charging port or charging port cover on your VMAXVX2 EXTREME E-Scooter VX2 EXTREME .

Model VX2 EXTREME
Time required approx. 15–25 minutes
Difficulty medium

Tools Required

  • Phillips screwdriver
  • 16 mm open-end wrench
  • Optional: Spray adhesive or hot glue
Before you begin, make sure your VMAX E-Scooter is E-Scooter . Work on a stable surface and have all your tools within easy reach.

Instructions

1

Remove the rubber mat and screws

VX2 EXTREME the rubber mat and screws from the footboard of VX2 EXTREME

The charging port is located in the maintenance flap at the front of the scooter. First, remove the rubber mat at the front of the footboard.

Next, loosen the four screws (two at the top and two at the bottom of the running board).

2

Remove the maintenance access panel and disconnect the plug

Carefully remove the maintenance cover and disconnect the plug connection between the charging port and the battery.

3

Remove the charging port

The lock nut on the charging socket is loosened

Loosen the lock nut on the charging socket and remove the charging socket from the access panel.

4

Install new parts

Insert the new charging port or cover and secure it again with the lock nut.

5

Install the maintenance hatch and rubber mat

Reinstall the maintenance panel and tighten all screws.

The rubber mat usually stays in place just fine. If necessary, you can use a little spray adhesive or hot glue to help it stick.

Be sure not to glue the screws in place.

When assembling the unit, make sure that all screws are tightened properly and that no cables are pinched or damaged.

Check the result

After assembly, check that the charging port is securely in place and that the charging cable connects easily. Also check that the maintenance flap is securely fastened.

E-Scooter repairs, test your VMAX E-Scooter carefully while stationary or over a short distance before using it normally again in your daily life.

Frequently Asked Questions

Here you'll find answers to frequently asked questions about this repair.

Why do I have to remove the rubber mat?

The screws for the access panel are located underneath. You can't reach the charging port without removing the mat.

What should I do if the rubber mat no longer sticks well?

According to the instructions, you can use a little spray adhesive or hot glue to help secure the pieces. Be careful not to glue any screws together.

What should you do if the charging port doesn't work after installation?

Check the connection to the battery and make sure the charging port is securely connected. If the problem persists, the electronics should be inspected more thoroughly.

If you're unsure or need help, our local service teams are here to assist you.