Adjusting the Handlebars When They Are Crooked

Change Tires You're reading How to Align a Handlebar If It’s Crooked 2 minutes Continue Front wheel and drum brake
Tags

In this guide, we'll show you, step by step, how to correct a misaligned handlebar on your VMAXVX2 EXTREME E-Scooter VX2 EXTREME .

Model VX2 EXTREME
Time required approx. 5–10 minutes
Difficulty easy

Tools Required

  • Allen 5 mm
Before you begin, make sure your VMAX E-Scooter is E-Scooter . Work on a stable surface and have all your tools within easy reach.

Instructions

1

Locate the clamping device

If you want to realign the front wheel of your scooter with the handlebars, you'll need to loosen the clamp on the handlebar.

2

Loosen the top screw

Top screw of the clamping device on the handlebar of the VX2 EXTREME

Use the 5-mm Allen wrench to loosen the first screw on the clamping device.

3

Loosen the second screw

Second screw on the clamping device attached to the handlebar of the VX2 EXTREME

Next, loosen the second screw so that the handlebars can be adjusted.

4

Align the handlebars

It's best to hold the front tire between your feet and carefully turn the handlebars to the desired position until the front wheel and handlebars are aligned again.

5

Tighten the clamp again

Finally, tighten the clamp again to ensure that the handlebars are securely fastened.

When tightening, make sure both screws are tightened properly and evenly so that the handlebars are securely fastened.

Check the result

After aligning the handlebars, check to make sure they are once again aligned with the front wheel. Also check that the clamp is tight and that the handlebars cannot be twisted.

E-Scooter repairs, test your VMAX E-Scooter carefully while stationary or over a short distance before using it normally again in your daily life.

Frequently Asked Questions

Here you'll find answers to frequently asked questions about this repair.

What should I do if the handlebars twist again after a short time?

Check to see if both screws on the clamping device have been tightened evenly and securely. If the handlebars continue to twist, the clamping mechanism should be inspected more closely.

Do I need to loosen both screws, or is one enough?

According to these instructions, you should loosen both screws so that the clamping device can be adjusted properly.

Can I just use force to straighten the handlebars?

No, loosen the clamping mechanism first. This will prevent unnecessary stress on the components and ensure proper alignment.

If you're unsure or need help, our local service teams are here to assist you.